Atlas Copco QAS 60 Pd, Инструкция по эксплуатации

Страница: 76 / 142

- 76 -
5.5.5 Replacing fuel filter element
Replacing the filter element:
– Unscrew the filter element (FF) from the adapter
head.
– Clean the adapter head sealing surface. Lightly oil
the gasket of the new element and screw the latter
onto the header until the gasket is properly seated,
then tighten with both hands.
Check for fuel leaks once the engine has been
restarted.
5.6 Engine consumable
specifications
5.6.1 Engine fuel specifications
For fuel specifications, please contact your Atlas
Copco Customer Center.
5.6.2 Engine oil specifications
High-quality, mineral, hydraulic or synthesized
hydrocarbon oil with rust and oxidation inhibitors,
anti-foam and anti-wear properties is recommended.
The viscosity grade should correspond to the ambient
temperature and ISO 3448, as follows:
Specifications PAROIL
PAROIL from Atlas Copco is the ONLY oil tested
and approved for use in all engines built into Atlas
Copco compressors and generators.
Extensive laboratory and field endurance tests on
Atlas Copco equipment have proven PAROIL to
match all lubrication demands in varied conditions. It
meets stringent quality control specifications to
ensure your equipment will run smoothly and
reliably.
The quality lubricant additives in PAROIL allow for
extended oil change intervals without any loss in
performance or longevity.
It is strongly recommended to use
Atlas Copco branded lubrication
oils.
Engine Type of lubricant
between -10°C and 50°C
PAROIL E or
PAROIL E
Mission Green
between -25°C and 50°C PAROIL Extra
!
Never mix synthetic with mineral
oil.
When changing from mineral to
synthetic oil (or the other way
around), you will need to do an
extra rinse.
After doing the complete change
procedure to synthetic oil, run the
unit for a few minutes to allow good
and complete circulation of the
synthetic oil. Then drain the
synthetic oil again and fill again
with new synthetic oil. To set correct
oil levels, proceed as in normal
instruction.
!