51
7 - EXPERT MODE
Before taking any action, light up the screen by pressing a button.
This menu is used to access the advanced functions of the appliance.
Information
Provides information about the appliance that might be requested should you contact the After
Sales Service.
Settings
General
Clock
Automatic transition to/from daylight saving time.
This is used to activate or deactivate the automatic transition to/
from daylight saving time.
By default, this setting is deactivated.
Date and time.
Language
This is used for language selection: French, English.
Reset
This is used to reset the appliance to factory settings (Auto
mode activated, setpoint at 19°C, reduction of 3.5°C, detection
functions activated). Appliance pairing, connection to the
application or connection to a control point will be deleted.
Function
config.
Temperature
calibration
It is possible, depending on your installation, that you will record
a temperature that differs from that displayed on the appliance.
Before taking any action, allow at least 6 hrs. in Comfort mode
for the temperature to stabilise at the desired temperature.
You can then calibrate your appliance to adjust the setpoint
temperature to the room"s temperature reading. The calibration
value is between -3°C and +3°C.
E.g. the temperature displayed on your radiator is 20°C. The
one displayed on your thermometer is 18°C => choose a -2°C
calibration value.
Window
detection
In the case of pairing, this is used to deactivate the open window
detection on this appliance only. Deactivating the function on
this appliance does not deactivate the function on the other
paired appliances, and allows it to monitor the open window
detection function of the other paired appliances.
Deletion
Reserved for radio-controlled appliances.
This is used to reduce the setpoint temperature by -1°C
to -2°C during peak rate periods. Depending on the system
installed, a private radio message is sent to you informing you
of these periods.
Circle luminosity This is used to adjust the brightness of the circle around the
On/Off button.
