36
If the control or controlled device is protected by a 30mA residual-
current circuit-breaker protective device (e.g. in the bathroom) then
the power supply for the pilot wire on this differential needs to be
protected.
1.2.3 - Bolt the appliance to the hanging bracket
1.3 - Installing Vertical appliances
Once the you have removed the appliance from its cardboard box,
you will find a cardboard hole drilling template
1.3.1 - Preparation for the installation of the hanging brackets
-
Use the mounting template.
•
Locate the centre line of the
appliance shown as a dotted line.
•
Locate the 4 drilling points for
mounting the radiator and mark
them with a pencil.
- Drill the 4 radiator mounting holes
and insert the wall plugs.
-
Insert the screws in the wall plugs
(the screws can stand out 6mm
max.).
-
Use a screwdriver to unscrew the
appliance"s hanging lugs.
Use screws and wall plugs that
are suitable for your wall type
and the weight of the appliance
(screws and wall plugs are not
supplied).
-
Mount the appliance on the S bracket as shown
in the
diagram.
- Move the appliance towards the bracket, then lift
the appliance (arrows 1 and 2).
- Insert the mounting brackets into the holes on the
appliance, then lower the appliance (arrow 3).
- Bolt it by half-turning the 2 locking bolts V, your
appliance is mounted
.
2
S
1
3
V
Mark lower holes
1000W, 1500W, 2000W
Mark holes 1000W
Mark holes 1500W
Mark holes 2000W
500
264
Bottom of the appliance
Ground
1545
1101
1268
1700
422
120
