Athena 1090 EVO, Перевод оригинальной инструкции, Страница: 39 / 182

39
The photo above shows how the locking system of the extensible structure
must be positioned during maintenance work. By means of the "ground
controls", it is possible to lift the work platform until it is possible to place
the two locking brackets vertically and aligned with the pins below.
Subsequently lower the work platform until the brackets are locked in the
relative pins.
•
Protect the environment: avoid spilling oil when changing it or topping up.
Used oil must be disposed of in accordance with the laws in force.
•
Never insert the body, limbs or fingers in sharp, jointed opening on the
machine that is not controlled or without proper guards unless securely
blocked.
•
Do not use petrol, solvents or other flammable liquids as detergents.
Always use authorized non-flammable and non-toxic commercial products
•
Do not use open flames for lighting purposes when performing maintenance.
•
Make sure there are no fluids under pressure before disassembling unions
or pipes: oil spattering out under pressure can cause serious injuries.
Immediately call a physician if injuries occur or the fluid from pipes is
accidentally ingested. Remember that fluid seeping from a very tiny hole
can be almost invisible but possess sufficient force to penetrate under the
skin. Use a piece of card or wood to check for leaks.
•
Make sure that all parts of the hydraulic circuit have been tightened
correctly
•
When compressed air is used for cleaning parts, protect yourself by
wearing safety goggles with side guards and limit the pressure to 2 atm
maximum. (1.9 bar).