Athena 1090 EVO, Перевод оригинальной инструкции, Страница: 35 / 182

35
2.9 Mandatory safety indications to follow before lifting the work
platform above the transport height
The instructions given below must be followed.
After having levelled it, lift the work platform only after making sure, both
visually and by moving inside the work platform, that all 4 ends of the tracks
rest on the ground.
Avoid the following situation for both tracks:
The ring gear of the wheel drive units and the track tensioner wheels must all be
resting on the ground.
If even one of them is not in contact with the ground, the stabiliser area will be
reduced and, consequently, the platform will be unstable and there will be the
risk of overturning.
2.10 Safety checks on the operation of the platform, to be performed
before use
The instructions given below must be followed.
•
With the platform in the transport configuration, place the machine with the
frame tilted with respect to the horizontal by a value greater than 0.5° on
the lateral. Operate the platform lifting control, make sure that the system
automatically brings the frame to the horizontal position
•
With the platform in the transport configuration, place the machine with the
frame tilted with respect to the horizontal by a value greater than 0.5° on
the longitudinal. Operate the platform lifting control, make sure that the
system automatically brings the frame to the horizontal position
•
With the platform in the transport configuration, place the machine with the
frame tilted with respect to the horizontal at the maximum angle both on
the longitudinal and on the lateral. Operate the platform lifting control,
make sure that the system automatically brings the frame to the horizontal
position
•
Lift the platform without a load to the maximum height and then lower it a
few times; make sure that the machine works correctly