Atag iC 24, Инструкция по установке и обслуживанию

Страница: 23 / 62

Installation & Servicing instructions ATAG iC-Range
23
9.8 Flue gas exhaust system
The fl ue gas exhaust system and air supply system consists of:
- Flue gas pipe;
- Air supply pipe;
- Roof or wall terminal.
The fl ue gas exhaust system and air supply system must comply with:
The fl ue gas outlet and air supply installation must comply with the current regulation requirements in
accordance with BS:5440 Part 1 and 2.
The ATAG iC boiler as described in this manual is NOT suitable for a combined fl ue system.
The appliance concentric connection diameter is 60/100 mm, to which the fl ue gas outlet and air supply
system can be fi tted, with or without elbow pieces. The maximum permissible pipe length is set out in Table
9.8.2.a.
For further information about the available components of the fl ue gas and air supply system we recommend
you consult the Flue system literature. Combinations with other brands or systems are, without written
permission from ATAG Heating, not permitted.
The ATAG fl ue gas system is meant, and designed, solely for the use on ATAG central heating boilers
adjusted to Nat gas or LPG. For this purpose the CE Certifi cate has been supplemented under the Gastec
nr: 0063CQ3634 The maximum fl ue gas temperatures are below 70°C (full load 80/60°C).
The proper operation may be adversely infl uenced by changes of or adjustments to the correct set up.
Possible warranty claims will not be honoured if incorrect changes result in non compliance with the
installation manual or local rules and regulations.
P/A
Room sealed system Figure 9.8.a
P/A P/A P/A
LEGEND:
P/A
Polypropylen / Aluminium
Room sealed system
Boiler Class C
Permitted only
when the air
intake and the fl ue gas
outlet are in the same
pressure area.