Assa Abloy 5800 ADAEZ PRO, Инструкция по установке и эксплуатации

Страница: 40 / 50

700002-Rev N 09/18
®
5800 ADAEZ PRO
Installation and Operation Instructions
40 of 50
Troubleshooting
14
Symptom
• Refer to section titled “Programming the Operator” and Auto-Setup the
operator.
Recommended Remedy
• Refer to section titled “Programming the Operator” and Auto-Setup the
operator.
• Refer to section titled “Programming the Operator” and Auto-Setup the
operator.
• Loosen the nuts on the back of the switch plate assembly to ensure
that the switch is not stuck in the closed position.
o Refer to Figure 17.
• Refer to section titled “ Customizing Operator Settings ” and adjust the door
hold open time.
• Refer to section titled “ Customizing Operator Settings ” and adjust the door
hold open time.
• Refer to section titled “ Customizing Operator Settings ” and adjust the door
open force.
• Insert a small flat head screwdriver into the slot above the T-channel and
gently pry the battery from the operator housing.
• Verify that the CR2032 battery installed in the RF transmitter is good by
ensuring voltage is 2.8VDC or greater.
o Refer to section titled, “Installing the Door Arm.”
• Set and RF switch with a door controller following the instructions in
the section titled “Linking the RF Pushbuttons.”
• Door arm has slipped on the output shaft.
o Refer to Figure 15 (push-side application) or 26 (pull-side application).
o Loosen the three door arm coupling screws.
• Door arm end link washer has not been installed.
o Install supplied washer. (Two are supplied; only one is required.)
o Refer to Figures 13 (push-side application) and lower door operator
using the slotted mounting holes in the mounting bracket.
• Refer to section titled “Linking the RF Pushbuttons” and erase all activation
codes. THEN:
• Refer to section titled “Programming the Operator” and Auto-Setup the
operator.
• Refer to 9, and note the T-shaped channel at the top of battery Figure 2
housing.
o Ensure the door arm is touching the face of the door.
o Tighten the door arm coupling screws evenly (one quarter turn at a
time) until fully tight. Be sure screws are tightened securely.
• Refer to section titled “ Customizing Operator Settings ” and adjust the door
close time.
• Door arm rubs on door arm pivot bracket.
Door Opens Too Slow
Door Closes Too Fast
Door Closes Too Slow
Door Opening Force Too High
Can't Remove Battery
From Housing
Can't Initialize RF Buttons
Door Stays Open at 90 Degrees