NOTE:
When attempting to install the rivnuts to the
underside of the door frame it may be necessary to
remove the door stop.
2. Refer to Figure 11 and, using a center punch,
MARK the door arm pivot bracket hole locations.
c. INSTALL and TIGHTEN the three (minimum) ¾
"
socket head capscrews securing the door arm
pivot bracket to the underside and face of the
frame header.
4. If the door frame is wood, PERFORM the following:
CAUTION
b. INSTALL and TIGHTEN the three #14 x 1-¼"
wood screws (minimum) securing the door arm
pivot bracket to the underside and face of the
frame header.
To ensure proper installation, the door arm pivot
bracket must be fastened to the underside of the
header frame and to the face of the header frame with
at least
three fasteners.
b. Using the provided rivnut installation tool,
INSTALL the ¼-20 steel rivnuts.
3. If the door frame is aluminum and rivnuts must be
installed, PERFORM the following:
a. Using a 25/64
″
drill, DRILL the door arm pivot
bracket holes.
a. Using a 5/32
"
drill, DRILL the door arm pivot
bracket pilot holes.
Figure 11
700002-Rev N 09/18
®
5800 ADAEZ PRO
Installation and Operation Instructions
15 of 50
Operator And Door Arm Installation Instructions - Push Side Applications
6
OPERATOR MOUNTING BRACKET
FOR NARROW STILE DOORS
OPERATOR MOUNTING BRACKET
FOR ALL OTHER DOORS
DOOR ARM PIV
O
T SHOE CENTERLINE
FOR BUTT HUNG OR OFFSET PIV
O
T DOORS
DOOR ARM PIV
O
T SHOE CENTERLINE
FOR CENTER PIV
O
T DOORS
MARK HOLE LOCATIONS
MARK HOLE LOCATIONS
