1. ROUTE transformer wiring to a 110-VAC outlet, but
do not plug transformer into the outlet.
• MOUNT one end link in the area behind or
next to the battery pack.
USE 24VDC CLASS 2 TRANSFORMER ONLY
NOTE:
If possible, the transformer wiring should be
routed against the door trim molding.
NOTE:
An optional plug-in transformer is
recommended in installations where the automatic
door-opening feature will be used frequently. The
optional plug-in transformer is REQUIRED for
installations where Power Close and/or Push and Go
features are enabled.
2. Refer to Figure 29, and ROUTE wires through
armored cable end links. MOUNT the door cord
end links as follows:
• MOUNT the other end link on or next to the
door frame.
Miscellaneous Common Insructions
8
700002-Rev N 09/18
®
5800 ADAEZ PRO
Installation and Operation Instructions
31 of 50
Installing the Plug-In Transformer
Figure 29
SEE DETAIL A
ROUTE WIRE INTO
END LINK FROM
FRONT
ROUTE WIRE THROUGH
EXIT AT BOTTOM
SIGNAL INPUT
CHARGER INPUT
GROUND (COMMON) INPUT
24VDC (POSITIVE) INPUT
EZ061
DETAIL A
Copyright © 2018, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA
ABLOY Accessories and Door Controls Group, Inc. is prohibited.
