Ashley Ashley AP5660, Инструкция по установке и эксплуатации

Страница: 25 / 36

Trouble Shooting Guide
When your stove acts out of the ordinary, the fi rst reaction is to call for help. This guide may save time and money by
enabling you to solve simple problems yourself. Problems encountered are often the result of only fi ve factors: 1) poor fuel;
2) poor operation or maintenance; 3) poor installation; 4) component failure; 5) factory defect. You can usually solve those
problems related to 1 and 2. Your dealer can solve problems relating to 3, 4 and 5.
For the sake of troubleshooting and using this guide to assist, you should look at your heat level setting to see which light
is fl ashing.
• Disconnect the power cord before performing any maintenance! NOTE: Turning the ON/OFF Switch to ”OFF”
does not disconnect all power to the electrical components of the stove.
• Never try to repair or replace any part of the stove unless instructions for doing so are given in this manual.
All other work should be done by a trained technician.
Display is Flashing “E1”
Possible Causes Possible Remedies: (Unplug stove fi rst when possible)
1. The convection blower is overheating and tripping the
internal temperature shutoff. Clean any dust off of the windings and fan blade. If oiling
the blower does not help, the blower may be bad.
2. The stove is being left on the highest setting for extended
periods of time.
If operating the heater on the highest heat setting, the room
temperature could increase enough and lead to potential
overheating situations. If this happens try operating at a
lower heat setting.
3. Fuel other than wood pellets is being burned in the stove.
This pellet stove is designed and tested to use wood pellets.
Check for signs of fuel other than wood pellets. No other
types of fuel have been approved for this pellet stove. If
there are signs of other types of fuel being used, stop using
them immediately.
4. Power surge or brown out situation.
A power surge, spike, or voltage drop could cause the high
limit switch to trip. Check to see if a surge protector is being
used on the stove. If not, recommend one to the customer.
5. High Limit Switch is malfunctioning. If the other items check out OK, replace the high limit switch.
25