Page 22
Bolt Retries:
To enable this feature, tap the radio button on the task setup screen under the number of bolts. Set the number of
retries before lockout by tapping the number and inputting the desired value.
A retry is counted when the tool is put
into reverse and triggered (run).
After the designated value of retries have been attempted, the tool will not perform
another rundown
without tapping the ‘reset’ button on the ‘Run Tool’ screen.
If bolt retries are not enabled, the
controller will advance the bolt count to the next one in sequence regardless of a pass or fail.
Must Retry Failures:
To enable this feature, tap the radio button on the task setup screen under the bolt retries. With this feature
enabled, any failed rundown will require a retry and successful result before proceeding to the next rundown in
sequence.
A retry is counted when the tool is put into reverse and triggered (run)
. Once the previously failed
rundown is successfully completed, the bolt count will advance with the next trigger of the tool. If the attempted
numbers of retries are unsuccessful, the tool will be disabled until the reset button is pressed. See the password
screen to enable operator lockout.
Reverse Settings:
In each task, the reverse settings must be defined. More specifically, when the reverse button on the tool is pressed and
released (and the colored LED lights on the tool are flashing), the user must tell the controller how fast to turn, what
direction, and at what percent of the tool’s maximum torque. For inst
ance, if a 50 inlb tool is connected to the
controller, and the Reverse Power is set to 50%, the tool will be able to use 25 inlb of torque to remove a fastener
before the tool stalls. These reverse settings can be different for each task in the controller if the user wishes, or they
can all be set identically for uniformity.
Reverse can also be disabled by using the arrow button to cycle the direction through CW and CCW to Disabled. When
disabled, the tool can be put in reverse mode by pressing and releasing the reverse button, but the tool will not run
when triggered, a message will appear on the screen indicating that reverse is currently disabled.
CAUTION: Be sure to test and verify the reverse settings function as desired for a given application to avoid any
injury or damage to parts or equipment.