Ascension laserBIRD, Инструкция по установке и эксплуатации

Страница: 47 / 98

laserBIRD™ Installation and Operation Guide
40
40 40
40
RS232 Signal Description
A pinout and signal description of the RS-232C interface is found below. Note that The Bird
requires connections only to pins 2, 3 and 5 of the 9-pin interface connector.
The Bird's 9-pin RS-232C connector is arranged as follows:
PIN RS232 SIGNAL
1
DIRECTION DESCRIPTION
2
Receive Data Bird to host Serial data output from The Bird to the host
3 Transmit Data host to Bird Serial data output from the host to The Bird
5 Signal Ground Bird to host Signal reference
7 Request to Send host to Bird Holds The Bird in RESET when high
Notes:
1) These are the Electronic Industries Association (EIA) RS232 signals names. The Bird is
configured as Data Communication equipment (DCE) and therefore Transmit Data is an input
and Receive Data is an output.
Using the 'reset on CTS' feature
The laserBIRD can be configured to perform a system reset when pin 7, its CTS line (RTS on
HOST side) is held high. This provides an alternative to issuing the RESET command, if the state
of the firmware is unknown. To enable the feature, check the appropriate box in the Settings tab of
the laserBIRD Utility.
NOTE: Users running applications in a Windows® environment who would like to enable this
feature, should take steps to ensure that command of this line (and of the serial port) is clearly
asserted.