Ascension laserBIRD, Инструкция по установке и эксплуатации

Страница: 85 / 98

laserBIRD™ Installation and Operation Guide
78
78 78
78
2. Additional queries will return and clear the next Error code in
the buffer, until the buffer. is empty. When the buffer is empty,
the query will return '0'.
Note: If the query returns '45', then the 16-byte(16 error codes)
buffer has overflowed, and the newest codes generated will be lost.
Error Code Listing
CODE ERROR DESCRIPTION
0
No Error
Cause: SYSTEM ERROR register empty
3
Scanner Configuration Data Corrupt
Cause: The system was not able to read the Scanner configuration data
Action: Reset the system
5
Sensor Configuration Data Corrupt
Cause: The system was not able to read the Sensor EEPROM configuration data, or the
Sensor is not plugged in.
Action: Insure that the Sensor is present, calibrate the sensor
6
Invalid RS232 Command
Cause: The system has received an invalid RS232 command, which can occur if the user
sends down a command character that is not defined or if the data for a command does not
make sense (i.e., change value commands with an unknown parameter number).
Action: Only send valid RS232 commands to The Bird.
11 RS232 Receive Overrun or Framing Error
Cause: An overrun or framing error has been detected by the serial channel
UART as it received characters from the user's host computer on the
RS232 interface.
Action: If an overrun error, the baud rate of the user's host computer and The
Bird differ. This may be due to incorrect baud selection, inaccuracy of
the baud rate generator, or the RS232 cable is too long for the
selected baud rate. If a framing error, the host software may be
sending characters to its own UART before the UART finishes
outputting the previous character.
18 Illegal Baud Rate Error
Cause: If the baud rate setting is in an 'invalid' baud rate setting then this
error will occur.
Action: Set up baud rate with a valid setting.
36 Invalid Motor Speed
Cause: Scanner motor speed is out of range. May be caused by excessive
movement or vibration of the Scanner unit
Action: Steady the Scanner or reset the system.
37 DSP POST error