Arjo MAA2050M, Инструкция по эксплуатации

Страница: 9 / 96

9
Detach the Loops (2 steps)
Make sure that the weight of the resident is taken up
by the receiving surface before removing the loop.
Method 1
1. Press the spring loaded latch open.
2. Remove the loop.
Method 2
1. Pull one side of the loop over the hook and spring
loaded latch.
(See Fig. 7 )
2. Pull down the loop.
(See Fig. 8)
Applying the Sling
In Bed (24 steps)
It is recommended that all patients with double
amputees are transferred from a fl at surface.
For transfer/transport/bathing see respective lift
IFU .
1. Place the lift nearby.
2. Apply bed brakes and adjust the height of the bed
to an ergonomic position, if possible.
3. The patient needs to lay down fl at on his/her back.
4. Check that the stiffeners are completely inside the
stiffener pockets, if any.
5. Fold the sling lengthwise along the centre line,
outside facing outside. The sling label is located on
the outside.
WARNING
To avoid injury during log roll, make sure
there is another caregiver present and/or
use the side rails on the opposite side of
the bed.
6. Log roll the patient. (Use local technique.) If log
roll is not possible, use an ArjoHuntleigh sliding
sheet/tube for placing the sling. See respective
Sliding sheet/tube IFU
7. Place the folded sling over the patient’s side. Make
sure that the centre line is aligned with the patient’s
spine, starting at the coccyx. Place the leg fl aps
towards the leg(s)/limb(s).
(See Fig. 9 )
8. Fold down the top of the sling and tuck it under the
patient’s body.
9. Log roll the patient to the other side.
10. Pull out the remaining part of the sling from under
the patients body.
11. Return the patient to his/her back.
12. Place the leg fl aps underneath the patient’s leg(s)/
limb(s). If using a Hammock sling, there are no leg
straps just general straps.
13. If using a loop sling, cross the leg straps. Pull one
strap through the other. (See Fig. 10 )
14. Make sure that the:
(See Fig. 11 )
• sling is centred and fl at without creases,
• sling’s head support covers the neck/head area,
• sling pieces are not twisted underneath the
patient and
• if a sling with commode is being used, make
sure the hole is positioned correctly.
WARNING
To avoid injury, make sure the patient’s
arms are placed inside of the sling.
15. Make sure the patient’s arms are inside the sling.
16. Place the lift next to the patient and apply the
brakes.
WARNING
To avoid injury to the patient, pay close
attention when lowering or adjusting the
spreader bar.
17. Attach the clips/loops.
18. Slightly lift the patient to create tension in the
sling.
(See Fig. 12 )
WARNING
To avoid the patient from falling, make sure
that the sling attachments are attached
securely before and during the lifting
process.
Continue with the steps on the next page.
Fig. 7 Fig. 8 Fig. 9 Fig. 10 Fig. 11
EN