Arjo Enterprise E8000X, Руководство по обслуживанию

Страница: 52 / 105

Servicing Instructions Enterprise E8000X Service Manual
Page 48
13 Attendant Control Panel - Replacement
This section describes how to replace the Attendant Control Panel (ACP). Reference is made throughout
this section to (“Electrical Assembly” on page 22) and (Figure 13 on page 47).
13.1 Removal
To remove the Attendant Control Panel:
13.1.1 Pry off the screw cover (Fig 13, Item 8). Remove two Ejot screws (Fig 13, Item 9) to release
either the ACP (Fig 13, Item 11).
13.1.2 Pull the ACP panel out of the foot end split side rail moulding (Fig 13, Item 1). Take care not
to strain the attached wiring.
13.1.3 The ACP and extension cables are joined by latching connectors, see Figure 14. Press down
the tab A on one side of the connector and pull the two cables apart.
Figure 14: Split side rail cable connector
13.2 Installation
To install the Attendant Control Panel:
13.2.1 Connect the ACP cable (“Electrical Assembly” on page 22, Item 21) to the ACP
(Fig 13, Item 11). Make sure the two halves of the connector latch together securely.
13.2.2 Install the ACP (Fig 13, Item 11) in the foot end split side rail moulding (Fig 13, Item 1). Tuck
any excess length of cable down inside the split side rail moulding.
13.2.3 Fit two Ejot screws (Fig 13, Item 9) to secure the ACP panel and refit the screw cover
(Fig 13, Item 8).
A