Arjo Enterprise E8000X, Руководство по обслуживанию

Страница: 38 / 105

Servicing Instructions Enterprise E8000X Service Manual
Page 34
7 Brake Pedal - Replacement
This section describes how to replace brake pedals.
Reference is made throughout this section to Figure 5 on page 36 and Table 3 on page 37.
7.1 Removal
To remove the brake pedals:
7.1.1 Position the bed so that all the castors are lined up in the same direction and apply the brakes.
7.1.2 On the right hand side of the bed only: carefully remove and discard the capped starlock
(Fig 5, Item 14) to release the brake link fabrication (Fig 5, Item 13) from the brake pedal
(Fig 5, Item 4A).
7.1.3 Remove the socket head screw (Fig 5, Item 12) and pull the brake pedal (Fig 5, Item 3A) or
(Fig 5, Item 4A) off the brake bar (Fig 5, Item 15). Remove the brake bow tube (Fig 5, Item 1)
if fitted.
7.2 Installation
To install the brake pedals:
7.2.1 Position the brake pedal (Fig 5, Item 3A) or (Fig 5, Item 4A) on the brake bar (Fig 5, Item 15).
Ensure the correct replacement pedal is fitted (i.e. left or right hand) and that the pedal end
points down. Install the brake bow tube (Fig 5, Item 1) if fitted.
7.2.2 Fit the socket screw (Fig 5, Item 12) to secure the pedal. Attach the brake link fabrication
(Fig 5, Item 13) to the pedal and secure it with a new capped starlock (Fig 5, Item 14).