Arjo AtmosAir SAT 4000 Series, Инструкция по эксплуатации

Страница: 17 / 40

13
CPR
1. Level bed.
2. Disconnect hoses from pump to level
mattress (for A and AR models), as shown at
right (Figure 9).
3. Lower or remove side rail on caregiver’s side
if necessary.
4. Begin CPR as per facility protocol. Consider
use of backboard if indicated.
5. After CPR is performed:
• Remove backboard if used.
• Reconnect pump hoses to mattress (for A
and AR models).
• Raise or install side rail as necessary.
•
Reconfigure bed and accessories as in
initial placement.
Transport Mode
When disconnected from the pump, the AtmosAir 9000A MRS will operate as a reactive
surface with the full operation of the SAT system. For transport, there are two options:
1. Disconnect the tube assembly from the mattress. Valves will close off as soon as
the tube assembly is disconnected.
2. Disconnect the tube assembly from the pump and securely place the transport
cap on the tube assembly to maintain a seal.
Skin Care
• Remove excess moisture and keep skin dry and clean.
• Check patient’s skin regularly, particularly in areas where incontinence and drainage
occur.
• Ensure linens under patient are not wrinkled.
Incontinence / Drainage
• Use moisture-impermeable underpads for incontinent patients.
• Wipe surface clean and replace bed linens as required (see Care and Cleaning ).
General Operation
Avoid contact of sharp instruments with the AtmosAir MRS.
Punctures, cuts and tears may prevent proper inflation and
air pressure maintenance.
Figure 9
Figure 10