20
Tensor
4) Select other relays
•
Button [M] > push 2 seconds
further see item 2) or 5)
5) Exit programming menu
•
Switch to AUTO mode.
During loss of supply voltage the current switching states remain unchanged. After switching
on again the relay states will be determined and set by means of the current sensor position.
6.5
Programming of the switching points with 7-segment display
1) Select programming mode
•
In hand mode push MENU button > 2s
the display shows „EL“
•
Select menu item RE via button [R] and confirm with [Menu].
2) Select relays
Select the desired relays with buttons [R] / [L]. The selected relays is shown in the display.
The additional fifth menu item E (EXIT) can be selected.
Confirm with [Menu].
3) Define/delete switching points
Now the switching points can be defined.
•
Set the desired position via buttons L / R, then save/delete:
The actual position is shown (0..100%).
By activating the buttons, the appropriate commands are issued:
•
[MENU] + [L]
SL
(Save Left) Save left switching point
•
[MENU] + [R]
St
(Save Right) Save right switching point
•
[L] + [R]
dE
(Delete)
•
[MENU]
E
(EXIT)
4) Select other relays
•
Push button [M] > 2 seconds
further see item 2) or 5)
5) Exit programming menu
•
Select menu item E (EXIT) and confirm with [MENU]
ADVICE
!
Содержание Tensor Zone 2/22
Страница 43: ......
