4 — English
UNPACKING
This product requires assembly:
Carefully remove the product and any accessories from
the box. All items listed in the
Includes
section must be
included at the time of purchase.
WARNING:
Items in this
Assembly
section are not assembled to
the product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.
Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
If any parts are damaged or missing, please call
1-877-297-8911 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
This misting kit is only intended for use with high pressure
pumps and connection hoses that are designed for high
pressure misting kits. Do not use a pump that has a
pressure rating greater than 1,000 PSI and a flow rate
of 1.0 gallons per minute. Contact the manufacturer
of the high pressure pump to determine the properly
rated connection hose for use with this pump. Use with
any other pumps or connection hoses can damage the
misting kit and result in possible serious personal injury
and/or property damage.
ASSEMBLY
INSTALLING/REMOVING SLIP LOCK
ACCESSORIES
See Figures 1 - 2.
To connect a slip lock accessory:
Insert steel misting tube into slip lock accessory. Once
the tube has been fully inserted, it will automatically lock
in place.
Pull on the slip lock accessory to be certain it is properly
secured.
To remove a slip lock accessory:
Push the steel misting tube and inner ring toward the slip
lock accessory to disengage the lock.
While holding the inner ring against the slip lock accessory
with one hand, pull the steel misting tube out with the
other.
NOTE:
Follow the steps above to remove slip lock
accessories. Excessive pulling without fully depressing the
inner ring can damage the accessory.
ASSEMBLING THE MISTING KIT
See Figures 1 - 11.
To ensure the product functions properly, always flush and
test the system for leaks before use.
Using a garden hose (not provided), flush debris out of
the nozzles, misting tubes, and connectors.
Turn off the garden hose (not provided) and disconnect
the pump from the power supply.
Assemble the garden hose (not provided) to the pump and
prepare it for use as described in the pump’s operator’s
manual.
Attach the threaded end of the hose adaptor (not provided)
to the pump outlet and hand tighten.
See figure 3
.
Attach the other end of the hose adaptor (not provided)
to a steel misting tube.
See figure 4
.
Connect two additional misting tubes to the assembly using
the slip lock connectors without fittings.
See figures 5 - 6
.
Using the elbow connector, connect a fourth misting tube
to the assembly forming a right angle.
See figure 7
.
Connect the remaining misting tubes to the assembly
using the slip lock connectors with fittings.
See figure 8
.
Install nine nozzles into the slip lock connectors with
fittings and hand tighten.
See figure 9.
Insert the end plug and thread the drain valve into the
slip lock connector farthest from the pump outlet.
See
figures 10 - 11
.
NOTE:
Do not disassemble the drain valve.
Place the completed misting tube assembly on a flat
surface and angle the assembly so that the nozzles face
away from you, others, and any electrical devices.
Connect the pump to the power supply.
