Arctic Cat ZR 5000 2015, Руководство оператора

Страница: 36 / 64

32
11. On the 5000/9000, open the air
bleed bolt located on the oil pump
(beneath the coolant tank) to purge
air from the oil hose.
PC016A

NOTE: When air can no longer be
heard purging from oil pump bleed,
tighten the bleed bolt to 7.5 ft-lb.
12. Without starting the engine, place
the handlebar emergency stop
switch to the RUN position and the
ignition switch to the ON position.
On the 5000/90000, the Oil Pressure
Warning Icon should illuminate.

NOTE: If the warning icon does not
illuminate, take the snowmobile to
an authorized Arctic Cat Snowmo-
bile dealer for service. If not under
warranty, this service is at the dis-
cretion and expense of the snowmo-
bile owner.
13. If the warning icon illuminates (from
step 12), start the engine. The warning
icon should go out within five seconds.
If it does, proceed to step 14.

NOTE: On the 7000, the engine
may need to be started 2-3 times
before it will stay running.

NOTE: If the warning icon does not
go out, shut the engine off immedi-
ately and repeat step 11; then place
the ignition switch to the ON posi-
tion and repeat step 13. If the warn-
ing icon does not go out, take the
snowmobile to an authorized Arctic
Cat Snowmobile dealer for service. If
not under warranty, this service is at
the discretion and expense of the
snowmobile owner.
14. Shut the engine off; then add oil to
the oil tank until oil is visible half-
way up in the sight glass.

NOTE: If the oil and engine are not
at operating temperature, the oil
level may read too low. Always make
sure the engine is at operating tem-
perature before checking the oil.
15. Install the access plate and torx-head
screws beneath the snowmobile;
then install the hood and access pan-
els.
Coolant Level

NOTE: Use a good quality, ethyl-
ene glycol-based, automotive-type
coolant.

NOTE: Always check the coolant
level with the engine cold.
7000
Locate the filler neck located above the
resonator; then remove the coolant cap
from the filler neck. Verify that the coolant
is at the bottom of the tab in the filler neck.
0747-547

NOTE: Under normal conditions
checking only the overflow tank
(located above the drive clutch) is
acceptable. Only if this tank does not
have coolant should the operator
have to remove the hood and check
the level at the filler neck.
Locate the coolant tank above the drive
clutch; then remove the plug from the
coolant tank. Add coolant to the full level
on the tank. Install the plug.
CAUTION
Do not attempt to start the engine
with the bleed bolt open.