48
Rear spring pre-load adjustment is
accomplished by loosening the adjuster
nut locking collar (B) from the adjuster
nut (A) and using the Spring Adjuster
Tool from the tool kit, rotating the
adjuster nut in whichever direction is
desired. Tighten the locking collar
against the adjuster nut.
0745-159
Lights
For the correct headlight bulb and/or tail-
light/brakelight LED, see the appropriate
specifications sheet.
Removing and Installing
Taillight/Brakelight
These models are equipped with an LED
taillight/brakelight. If the LED fails, it
must be replaced. To remove and install
the LED, use the following procedure.
746-097B
1. Disconnect the taillight harness con-
nector.
2. Remove the two torx-head screws
securing the taillight to the bracket.
3. Connect the taillight harness connec-
tor; then secure the taillight to the
bracket with the two torx-head screws.
Removing/Installing
Headlight Bulb
NOTE: The bulb portion of headlight
is fragile. HANDLE WITH CARE. When
replacing the headlight bulb, the bulb
assembly must first be removed from
the housing. Do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a dry
cloth before installing.
1. Disconnect the headlight harness
connector from the bulb; then
remove the rubber grommet from
the headlight housing.
2. Rotate the bulb retainer counter-
clockwise until it unlocks from the
housing; then remove the bulb.
0746-096
3. Install the bulb and retainer; then
rotate the retainer clockwise until it
properly locks in place.
4. Install the rubber grommet; then
connect the headlight harness con-
nector to the bulb.
5. Check headlight aim.
Adjusting Headlight Aim
The headlight can be adjusted for vertical
aim of the HIGH/LOW beam. The geo-
metric center of HIGH beam zone is to be
used for vertical aiming.
1. Position the snowmobile on a level
floor so the headlight is approxi-
mately 8 m (25 ft) from an aiming
surface (wall or similar surface).
! WARNING
Do not operate the snowmobile
unless headlight beam is adjusted
properly. An incorrectly adjusted
beam will not provide the operator
the optimum amount of light.
Содержание ZR 5000 2015
Страница 1: ...O P E R A T O R S M A N U A L www arcticcat com ZR 5000 7000 9000 XF 7000 9000 M 7000 9000...
Страница 7: ...3 Snowmobile Safety Rules...
Страница 60: ...56 NOTES...