Arctic Cat ZR 5000 2015, Руководство оператора

Страница: 18 / 64

14
0745-848
2. Adjust the handlebar to operator’s
desired position, tighten the cap
screws evenly to 15 ft-lb, and check
steering for maximum right/left
turning capabilities.

NOTE: Do not rotate the handlebar
to a position that allows air to enter
the brake system.
Speedometer/
Tachometer Angle
(5000/9000)
The speedometer/tachometer can be
adjusted to the operator’s desired position.
To adjust, use the following procedure.
1. Loosen the lock nuts and cap screws
on each side of the speedometer/
tachometer bracket.
2. Adjust the speedometer/tachometer
to the desired angle; then tighten the
lock nuts securely.
Exhaust System
The exhaust system is designed to reduce
noise and to improve the total perfor-
mance of the engine. If any exhaust sys-
tem component is removed from the
engine and the engine is run, severe
engine damage will result.
Air-Intake Silencer
Used in conjunction with the fuel intake
system is a specially designed air-intake
silencer. The purpose of the silencer is to
quiet the intake of fresh air. Since the fuel
intake system is calibrated with the air-
intake silencer in place, the engine must
never be run with the silencer removed.
Performance will not be improved if the
air-intake silencer is removed. In con-
trast, severe engine damage will occur.
Cooling System
These snowmobiles are equipped with a
closed liquid cooling system for engine
cooling. The cooling system should be
inspected daily for leakage and damage.
Also, the coolant level should be checked
daily. If leakage or damage is detected,
take the snowmobile to an authorized
Arctic Cat Snowmobile dealer for ser-
vice. If not under warranty, this service is
at the discretion and expense of the
snowmobile owner.
When filling the cooling system reser-
voir, use an ethylene glycol-based cool-
ant/water mixture which will satisfy the
coldest anticipated weather conditions of
your area in accordance with the coolant
manufacturer’s recommendations.

NOTE: If operating on ice or hard-
packed snow conditions, it is recom-
mended that Ice Scratchers (p/n 5639-
897) be installed and engaged to
reduce wear strip wear and engine
overheating.
For checking/filling cooling system, refer to
Coolant Level sub-section in the Mainte-
nance section.
Battery
It is extremely important that the battery be
maintained at full charge at all times and
that the battery connections be clean and
tight. If charging the battery becomes neces-
sary, refer to Battery sub-section in the
Maintenance section.
! WARNING
Tighten cap screws according to
specifications to prevent unexpected
“movement” of the handlebar during
operation over rough terrain. DO NOT
position the handlebar so steering
(maximum right/left turning capabili-
ties) or throttle and brake controls
are affected.
CAUTION
These snowmobiles are not designed
to be operated in dusty conditions.
Operating the snowmobile in dusty
conditions will result in severe
engine damage.