Arctic Cat ZR 5000 2015, Руководство оператора

Страница: 30 / 64

26
Lubrication
Chain Case

NOTE: The snowmobile must be
on a level surface for this procedure.
1. Check the lubricant level in the
chain case by using the sight glass.
0746-115

NOTE: The correct level is when
the lubricant is at least halfway up in
the sight glass.

NOTE: Adding lubricant can be
done by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for this service.
This service is at the discretion and
expense of the snowmobile owner
.
2. If the lube level is low, remove the
three screws securing the shift actua-
tor to the chain case, disconnect the
actuator wiring harness, and remove
the actuator w/extension; then add
appropriate amount of Arctic Cat
Synthetic Chain Lube (p/n 6639-
539) through the shift actuator open-
ing. When the lube is halfway up the
sight glass, install the shift actuator
w/extension and connect the actua-
tor wiring harness. Tighten screws to
36 in.-lb.
0748-259
3. Start the engine and verify proper
reverse and forward operation by shift-
ing in and out of reverse three times.

NOTE: If excessive build-up of
moisture or discolored oil is
detected in the chain case, it may be
necessary to replace the lube.

NOTE: Replacing the lubricant can
be done by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for this service.
This service is at the discretion and
expense of the snowmobile owner
.
To replace the lubricant, use the follow-
ing procedure:

NOTE: The side panels, hood, and
exhaust resonator must be removed
for this procedure.
1. Place a drain pan under the chain
case; then loosen the eleven screws
securing the chain case cover/oil tank
assembly to the chain case housing
starting with the bottom screws first.

NOTE: It is critical that the snow-
mobile is on a level surface to
ensure the lubricant drains properly
and completely.

NOTE: Inspect the chain case
cover seal for nicks or damage.
2. When the lubricant has completely
drained from the case and the chain
case is cleaned of old oil; then install
the chain case cover. Tighten the cap
screws to 12-14 ft-lb.
CAUTION
When installing the shift actuator,
rotate the actuator back and forth to
properly align it with the extension
gear. Failure to do so could cause
component damage.
CAUTION
Before installing the chain case
screws, be sure to clean the holes
using compressed air completely of
debris or damage to the chain case
may occur.