Arctic Cat ZR 5000 2015, Руководство оператора

Страница: 31 / 64

27
XM092
3. Remove the three screws securing
the shift actuator to the chain case,
disconnect the actuator wiring har-
ness, and remove the actuator w/
extension. Pour recommended chain
lube through the shift actuator open-
ing until the lubricant is at least half-
way up in the sight glass; then install
the shift actuator w/extension and
connect the actuator wiring harness.

NOTE: Make sure the reverse sen-
sor wire is routed up so the wires do
not become pinched between the
actuator and the case.
XM014A
4. Install and secure the exhaust reso-
nator.
5. Start the engine and verify proper
reverse and forward operation by
shifting in and out of reverse three
times.
Rear Suspension
This procedure should be done every 40
operating hours.

NOTE: Arctic Cat recommends
that Arctic Cat All-Temp Grease (p/n
4639-365) be used for this proce-
dure.
1. Using Handlebar Stand (p/n 5639-
152) or Steering Post Stand (p/n
5639-946) or a suitable substitute,
lay the snowmobile on its left side.
2. Lubricate all grease fittings with all-
temperature grease.
5000/9000
CAUTION
When installing the shift actuator,
rotate the actuator back and forth to
properly align it with the extension
gear. Failure to do so could cause
component damage.
CAUTION
The correct lubricant to use in the
chain case is Arctic Cat Synthetic
Chain Lube. Any substitute may
cause serious damage to the drive
system.