Arctic Cat ZR 5000 2015, Руководство оператора

Страница: 34 / 64

30

NOTE: On the 7000, the fuel filter is
located on top of the fuel tank. To
access the filter, the access panels,
hood, and console need to be removed.
XM184

NOTE: On the 9000, the fuel filter is
located between the gas tank and the
rear belt guard and is secured to the
tunnel with a filter bracket. To access
the filter, the left-side access panel
must be opened and the lower con-
sole must be unlatched and opened.
1. Remove the hose clamps and discard;
then slowly remove the fuel hoses
from the fuel filter. Dispose of the
excess fuel from the filter properly.
2. Inspect the fuel hoses thoroughly for
any signs of cracking, cuts, or wear
points.
3. Place the new hose clamps on the
fuel hoses; then with the fuel pump
inlet and outlet noted, connect the
fuel hoses to the fuel filter. Secure
with the hose clamps.

NOTE: After completing the chang-
ing of the fuel filter and the engine is
started for the first time, inspect the
filter area for any signs of leaks.
0746-802
Gasoline Additives
Fuel de-icer can be used for all models.
Arctic Cat Fuel Stabilizer (p/n 0436-907)
should also be added to the last tank of
gasoline before storage.
Fuel Pickup Valves
If ever there is a restricted fuel flow and a
pickup valve is suspected, take the snow-
mobile to an authorized Arctic Cat Snow-
mobile dealer for this service. If not under
warranty, this service is at the discretion
and expense of the snowmobile owner.
Checking Engine Oil
Level

NOTE: The engine must be at
operating temperature before check-
ing the oil level or an incorrect oil
level will result.
1. Park the snowmobile on a level surface;
then start the engine and allow to warm
up for 5-10 minutes, or if the snowmo-
bile was operated, allow the engine to
idle approximately 30 seconds.
2. Shut the engine off; then remove the
right-side access panel and verify oil
is visible at least halfway up in the
sight glass.
SNO-244A
3. If oil is not visible halfway up in the
sight glass, add recommended engine
oil until oil is visible half-way up the
sight glass.; then on the 5000/9000,
proceed to step 11 of Changing
Engine Oil/Filter in this sub-section.
CAUTION
Make sure the fuel filter is properly
seated into the holder located on the
tunnel behind the driven shaft.
CAUTION
If the engine and oil are not at operat-
ing temperature, the oil will not be
visible in the sight glass. Tip the
snowmobile to the right at a 45°
angle; then check to see if oil is pres-
ent in the sight glass.