Arctic Cat ZR 5000 2015, Руководство оператора

Страница: 24 / 64

20
2. The system will not shift until the
button is released.
3. To shift into forward, stop the snow-
mobile and allow the engine to idle
(under 2000 RPM); then press the
reverse button and release. The for-
ward selection will be complete.
4. After shifting from reverse to forward
(or from forward to reverse), apply
the throttle slowly and evenly to allow
the sprockets to engage properly.
5. The reverse function is cancelled
whenever the engine is shut off.
Access Panel/Hood
(Removing/Installing)
To remove the access panel and hood, use
the following procedure:
1. Remove the hairpin clip from the pin
located at the front of the access
panel. On the M/XF, remove the
thumb screw securing the front left
access panel to the front facia.
0746-800
2. Move the panel up and off the pin;
then swing the panel all the way out
and unhinge the panel from the
lower console.
3. Remove the torx-head screws secur-
ing the hood (located on the under-
side of the hood above the front tube
of the upper A-arm); then remove
the two torx-head screws from the
top-side of the hood securing the
hood to the upper console and the
two torx-head screws from under the
nosepiece of the hood.
0746-792
0747-529
0746-091
4. Remove the intake panel below the
gauge; then locate the hood harness
connector (located in front of the
speedometer) and unplug the con-
nector; then move the hood slightly
forward and remove the hood.
! WARNING
Do not use high speed when backing
up. Control could be lost and injury
could occur.
CAUTION
After reversing in deep powder snow
conditions, make sure the snowflap
does not become “caught up” in the
track. Track and/or snowflap damage
may occur.
CAUTION
If the snowmobile is equipped with
ice scratchers, the scratchers must
be disengaged or component dam-
age will occur.
5000
7000
9000