Arctic Cat ZR 5000 2015, Руководство оператора

Страница: 21 / 64

17

NOTE: The frequency of servicing
rebuildable shock absorbers will
vary according to the types of condi-
tions and terrain the snowmobile has
been subjected to. If riding quality
deteriorates (or seems to be deterio-
rating), take the snowmobile to an
authorized Arctic Cat Snowmobile
dealer for shock absorber evaluation
and/or servicing. This service is at
the discretion and expense of the
snowmobile owner.
Kits are available to either stiffen or
soften gas shock valving.
Standard Track (XF/ZR)
Accelerated wear strip and track clip
wear caused by operating on ice or hard-
packed snow conditions is NOT covered
under Arctic Cat Inc. warranty policy.

NOTE: If regularly operating on ice
or hard-packed snow conditions,
Performance Wear Strips (p/n 6639-
448) may be installed at the expense
of the snowmobile owner.
Paddle Track (XF High
Country/M)
These models are equipped with a Power
Claw style track which is specially
designed for use in powder snow riding
conditions. When the Power Claw track is
operated in hard-packed snow conditions,
it will run slightly slower than a standard
track and it will accelerate wear strip wear.
To decrease the amount of wear strip wear,
slower speeds must be maintained when
operating on hard-packed trails. Acceler-
ated wear strip wear caused by operating a
Power Claw track on hard-packed snow
conditions is NOT covered under Arctic
Cat Inc. warranty policy.

NOTE: If operating on ice or hard-
packed snow conditions, it is recom-
mended that Ice Scratchers (p/n 5639-
897) be installed to reduce wear strip
wear and engine overheating.
Track Studs (XF/ZR)

NOTE: Stud or hooker plate installa-
tion will void track and tunnel warranty.

NOTE: Arctic Cat does not recom-
mend studding a track with greater
than a 1.6 inch lug.

NOTE: Stud installation can be per-
formed by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat Snow-
mobile dealer for this service. This
service is at the discretion and
expense of the snowmobile owner.

NOTE: All 7000 models are manu-
factured with tunnel protectors.
For proper installation, use the following
procedure:
1. Using the appropriate stud template
(see chart), mark the desired stud
pattern to be used.
2. Using the proper-sized stud hole
drill bit, drill out the stud holes.
3. Push the stud through the hole from
inside the track; then place the
domed support plate and lock nut on
the exposed stud.
4. Using a wrench to secure the stud,
tighten the lock nut on the exposed stud.
! WARNING
When installing studs on a single-ply
track, it is important to use Arctic
Cat-approved studs (proper head
diameter). If approved studs (proper
head diameter) are not used, studs
could tear free of the track causing
possible injury or even death. Con-
sult an authorized Arctic Cat Snow-
mobile dealer for information.
CAUTION
To prevent tunnel damage from the
studs, Tunnel Protector Kit (p/n 6639-
075) for the ZR, (p/n 6639-118) for the
XF, or (p/n 6639-207) for HCR must be
installed.
Stud Template Chart
Track Length p/n
129 in. 6639-461
137 in. 6639-462
141 in. 4639-991