126
TA009
NOTE: The pinion seal must be replaced if removed.
10. Remove the inner snap ring on the front output shaft;
then using a mallet, tap the front output shaft down
into the case half. Account for the shim.
TA073A
11. Remove the outer snap ring and shim securing the ball
bearing; then using an appropriate tool, remove the
bearing.
TA013
TA127
SERVICING COMPONENTS
NOTE: If any bearing is removed, install a new bear-
ing using a suitable press.
NOTE: Keep all components in order for assembling
purposes.
A. Output Gear
1. Inspect the bearings for free and smooth turning. If
either bearing does not turn freely, it must be replaced.
TA016
2. Inspect the gear teeth for nicks, cracks, chips, or signs
of wear. If any are present, the gear must be replaced.
B. Intermediate Shaft
1. Inspect the bearing for free and smooth turning. If the
bearing does not turn freely, it must be replaced.
TA035
2. Inspect the gear teeth for nicks, cracks, chips, or signs
of wear. If any are present, the gear must be replaced.
CAUTION
There is a ball bearing below the pinion seal. Use cau-
tion not to damage the bearing while removing the seal.
CAUTION
When tapping the output shaft, make sure not to drop
the shaft when it releases from the bearing to avoid gear
damage.