66
ROV1-090A
6. Install the bottom end of the crankcase and install the exist-
ing eleven cap screws and washers. Tighten to 21 ft-lb.
ROV1-078A
NOTE: The longer fasteners go in the holes num-
bered one through six.
7. Rotate the engine to right-side up and install the remaining
crankcase cap screws and washers. Tighten the cap screws
(A) to 8 ft-lb and the cap screw (B) to 21 ft-lb.
KC550A
NOTE: The longer bolt is installed just to the right of
the oil filter.
8. Rotate the engine again and using a twelve-point
socket, tighten the connecting rods to 22 ft-lb, then to
36 ft-lb, and finally to 45 ft-lb.
ROV1-091A
NOTE: Rotating the crankshaft will aid in lining up
the fasteners.
9. Install the oil crossover tube. Tighten to 13.5 ft-lb.
ROV1-092A
NOTE: Verify the correct positioning of the washers.
10. Place the rubber O-ring into the oil pressure relief valve
bore; then push the oil pressure relief valve until the O-
ring on the valve is past the chamfer.
ROV1-095
