15
WT183A
5. Remove the stationary sheave and V-belt and any belt
threads or debris in the clutch housing or sheaves.
NOTE: If removing the stationary sheave, account
for the alignment shims in the moveable sheave (see
Servicing Left-Side Components in the Engine sec-
tion for proper shimming).
WT186A
INSTALLING
1. Making sure the directional arrows on the belt are aligned
with engine rotation, place the drive belt on the drive
clutch; then making sure the “X” marks are aligned, install
the alignment shims (if applicable) and stationary sheave
on the driven clutch.
WT517A
WT200A
2.
Using an appropriate strap or oil filter wrench (3 5/8”)
to hold the driven clutch and ensuring the splines of the
sheave and input shaft are engaged, secure the clutch
with the cap screw and washer. Tighten to 35 ft-lb.
WT202
3. Install the clutch cover and secure with the cap screws.
Tighten to 50 in.-lb.
WT182A
4. Install the left rear tire. Tighten in a crisscross pattern
in 20 ft-lb increments to 40 ft-lb (steel wheel) or 80 ft-
lb (aluminum wheel).