60
ROV1-108A
NOTE: Account for the different-lengthed fasteners
for assembling purposes.
NOTE: If the technician’s objective is to service or
replace the flywheel or starter gear, proceed to the
step 7; if not, continue to disassemble the bottom
side components without removing the flywheel or
starter gear.
7. Remove the cap screw securing the rotor/flywheel to
the crankshaft. Account for a washer and install the
crankshaft protector.
KC545
8. Using the flywheel puller, remove the flywheel.
KC546
9. Remove the starter gear leaving the flywheel key in
position.
KC543
10. Remove the starter idler gear and shaft.
ROV1-065A
11. Remove the two cap screws securing oil pump.
ROV1-063
12. Remove the oil pump leaving the chain on the top
sprocket. Account for two dowel pins and two O-rings.
ROV1-066
