6
6
WIRING CONNECTIONS
• Use only the cables provided with the ARAG computers.
• Take care not to break, pull, tear or cut the cables.
• Use of unsuitable cables not provided by ARAG automatically voids the warranty.
• ARAG is not liable for damages to the equipment, persons, animals or objects caused by failure to observe the above
instructions.
6.1
Camera connection
Navigator can be connected to one or two cameras
code 46700100
(purchased separately) using the suitable cables listed in the ARAG general catalog.
Connect the connector to the monitor (see connection points at par. 5.2) and the other cable end to the camera: ensure it is correctly in place and
turn the ring nut clockwise until blocking it.
6.2
Power supply connection
WARNING:
To avoid short circuits, do not connect the power cables to battery before the installation is completed.
Before powering up the navigator, make sure the tractor battery voltage is as specified (12 VDC).
Navigator is supplied directly by the farming machine battery (12 VDC): ALWAYS switch on the system through the computer, and then remember to
switch it off using the specific key on the control panel.
If the navigator remains on for a long time with machine off, the tractor battery could run flat: in case of prolonged breaks of the
machine with engine off, make sure the computer is off, too.
The power source must be connected as indicated in Fig. 5:
Fig. 5
Connect the power cable directly to the battery using the
suitable eyelets.
WARNING! DO NOT connect to key-operated switch (15/54).
6.3
SD memory card
The SD memory card may be used to exchange data
with the navigator.
Before using it make sure the card is not
protected (Fig. 6).
The system is ONLY compatible with SD or
SDHC memory cards.
Fig. 6
Fig. 7
Fig. 8
• Insertion:
Insert the memory card making sure to orient it correctly:
the card cut edge
A
must be face down. Push the card until it engages into place
and close the slot with the cover.
• Removal:
Press and immediately release the card into the slot and slide it out.
6.4
Pendrive
The pendrive may be used to exchange data with Navigator.
Before using it make sure the pendrive is not protected.
All pendrives with up to 8 GB memory are compatible.
INSTALLATION
