44
12.5
F5
Resume job
Enables procedure for resuming a previously saved job.
1
Press
F5
to resume a previous job, from the list of saved jobs.
As for the
New job
function (par. 12.3), if the current job has not been saved yet, Navigator will prompt the user to save it.
2
Select the job among those in the list (Fig. 163) and press
OK
to confirm the selection.
2a
When an "old" job is resumed, Navigator provides guidance information by restoring the conditions which were active at the time of saving.
If the
Loading options
screen is enabled (see par. 10.3.6), it is possible to choose which information to load (Fig. 164).
3
Press
OK
to switch to the guidance mode.
4
Complete the job (Fig. 165).
1
2
Fig. 163
Fig. 164
2a
In this screen it is possible to enable or disable the information memorized during the last saving
(
Value enabled,
Value disabled)
.
- Select, one by one, the parameters shown in the list and start the setup procedure:
• Applied area
disabling this parameter resets the relevant counter.
• Perimeter
disabling this parameter resets the calculated surface counter.
• Reference lines
• Points of interest (POI)
• Job data
disabling this parameter resets all counters; upon job loading a new spraying start date
and time will be saved.
- Select
Load...
and press
OK
to switch to
Spraying settings
.
3
4
Fig. 165
"HOME" MENU - F5 RESUME JOB
Par.
Exit the function
or data change
Confirm access
or data change
Scroll
(LEFT /
RIGHT)
Delete
selected
character
Data
increase /
decrease
Scroll
(UP /
DOWN)
Enter
selected
character
