AQUAPHOR APRO 1000 LPH, Руководство пользователя

Страница: 33 / 83

33
PROGRAM 01: FEED PUMP (XV -01)
If the input water does not meet the requirements of this manual for the minimum pressure and required volume, the
system can be connected to the existing water supply through the raw water supply system.
For this program, a pump for raw water should be added. By default, a storage tank with raw water is also added.
The raw water pump works under the following conditions:
▪
The program is activated
▪
The three-position switch is in the "AUTO" position
▪
There is enough water in the storage tank.
▪
There is a signal from the RO system to start work
PROGRAM 02: PRETREATMENT (PTS-01)
This program turns on the water pretreatment process.
The pretreatment system (PTS-01) will carry out the regeneration according to a
given program, and the results will be displayed on the controller screen. During this
period, the RO system is in waiting mode.
The time of the pretreatment regeneration does not depend on the controller settings.
When the pretreatment regeneration mode is activated, all RO system units turn OFF,
and the raw water feed pump turns on. After finishing the regeneration process, the
system continues to work automatically.
PROGRAM 03: FLUSH VALVE *
Presence
of a primary flushing valve. The valve is flushing the membranes before
start-up and shut down periods.
If the program is on (
✓
), the valve is normally closed and operating in
a described way. If the program is off, the valve closes when the maxi-
mum allowed value of LLS is exceed.
Current system is lacking flush valve.
Program is not required.