AQUAPHOR APRO 1000 LPH, Руководство пользователя

Страница: 67 / 83

67
8. Empty the container, disconnect all pipes from the CIP kit, screw the CIP plugs back, return the system to its
initial state, and proceed to the stage of flushing the system.
9. Move the switch at the top to the CIP position to enter the CIP mode.
a) Press
“Ok” ▀
button to open the Feed Valve (the solution starts flushing the system with raw water) and
leave for 10 minutes.
b) After 10 minutes, additionally press
“Up” ▲
button to turn the RO pump on and leave for 2 minutes.
c) Then press
“Ok” ▀
and
“Up” ▲
buttons and move the switch to the OFF position to exit the CIP mode.
d) Disconnect the permeate pipe from the consumer supply line and connect it to the drainage.
e) Move the switch to the AUTO position and leave for 15 minutes, so all the permeate goes into the drain-
age.
f) Make sure the system is running, and the conductivity and pH of the permeate meet the requirements
g) Return the permeate pipe to its original position.
10. System is ready.