Horizontal downflow pleated cartridge dust collector
7
7 ASSEMBLY
7.1 Required tools
The following tools and equipment are required for the assembly of the dust collector:
8 ASSEMBLY
1.
Prepare the area where the collector will be installed making sure it is clear and free of any
obstacle.
2.
Using eye bolts, slings and shackles, lift the dust storage section above the selected area and
set slowly.
3.
Once this section is firmly set to the ground, make sure it is level. Use anchor bolts to keep it
in place.
4.
Install a ground wire to the unit.
•
Crane or lift truck
• Spreader
• Chains
• Slings
• Shackles
•
Eye bolts
• Spikes
•
Wrench
•
Sockets
•
Power drill
•
Concrete drill bit
•
Concrete anchors
•
Bolts
•
Self tapping screws.
• Caulking
WARNING!
Apply two strips of butyl adhesive on the dust storage section upper
outline. One strip should be applied inward of the bolt holes and one
strip outward of the bolts holes
(figure 3).
5.
Lift the filter cabinet using the lift lugs. Using spikes, position the cabinet above the dust
storage section making sure to align the cabinet bolt holes with the dust storage section bolt
holes.
WARNING!
The use of a spreader is recommended to avoid damages to the filter
cabinet.
