Horizontal downflow pleated cartridge dust collector
15
Follow these steps to remove the drum from the collector:
1.
Hold up the drum
2.
Unlock the quick clip system
3.
Lower drum onto the ramp slides
4 .
Slide drum slowly toward you
WARNING!
Do not let drum fall free while unlocking the quick clip
system.
Be careful when releasing clip.
Follow these steps to install the drum back into position:
1.
Ensure the flange gasket seal is in place and intact. Replace if damaged.
2.
Slide the drum into the ramp slides.
3.
Check to make sure the drum flange is pushed at the end of the slide.
4.
Lift drum up.
5.
Attach the drum to the quick clip system
6 .
Check the seal assembly. Adjust quick clip system if there is a leak.
12.4 Anti-abrasive inlet
This option is recommended for the filtration of abrasive particles which may damage the filter
elements. A highly resistant steel plate slows down the particles and make them less abrasive on
the filters.
To change the abrasion plate, follow these steps :
1.
Remove the old plate and the gasket seal.
2.
Apply the new gasket seal on the abrasion plate.
3.
Install the new abrasion plate on the inlet using 3/8-16 nuts and bolts.
QUICK CLIP
LOWER FLANGE
DRUM
DOLLY
DIRTY AIR INLET
ABRASION PLATE
DUST COLLECTOR
CONNECTION
