Horizontal downflow pleated cartridge dust collector
8
6 .
Lower the filter cabinet onto the dust storage section and align both sections bolt holes.
7 .
Attach the filter cabinet to the dust storage section using the supplied nuts, washers and
bolts. Tighten bolts for an adequate seal.
8 .
Use caulking to eliminate possible leaks.
WARNING!
The use of improper lifting device may result in injuries or damages.
Adequate lifting devices are required and necessary precautions must
be taken when handling the equipment.
9 STRUCTURE ASSEMBLY
Generally, the support structure is factory assembled but because of shipping purposes, some
field assembly may be required. The next steps must be followed to assemble the dust collector
structure.
Drawing # 3
MAXITUBE
Page | 9
Baghouse Dust Collector
4.
Install a ground wire to the unit
.
5.
Lift t
he filte
r cabinet using the lift lugs. Using spikes, position the cabinet
above the dust storage section making sure to align the cabinet bolt holes
with the dust storage bolt holes.
6.
Lower t
he filte
r cabinet onto the dust storage section and align the bolt holes.
7.
Attach t
he fil
ter cabinet to the dust storage section using the supplied nuts,
washers and bolts. Tighten bolts for an adequate seal.
Figure 3
Support
plates
Support
legs
Cross braces
WARNING
Apply two strips of butyl adhesive on the dust storage section upper
outline. One strip should be applied inward of the bolt holes and one
strip outward of the bolt holes (Figure 4).
Figure 4
WARNING
The use of a spreader is recommended to avoid
d
amages to the filt
er cabinet.
Unside bag
removal
APPLY BUTYL
