Horizontal downflow pleated cartridge dust collector
9
1.
Vertically install the outer support legs.
2.
Install the cross braces with the hardware supplied as shown in figure 3. One is installed
inside of the legs and the other outside of the legs. Do not tighten the screws at this moment.
3.
With the use of a crane (or lifting device), slowly set the hopper onto the support plates.
Attach the support legs to the hopper using the supplied hardware.
4.
Level all components prior to tighten the cross braces using bolts, nuts and washers at meeting
point # 2. Anchor the hopper section into the ground using anchor bolts (not supplied).
5.
Withdraw the crane only when all components are firmly in place.
Drawing # 4
MAXITUBE
Page | 9
Baghouse Dust Collector
4.
Install a ground wire to the unit
.
5.
Lift t
he filte
r cabinet using the lift lugs. Using spikes, position the cabinet
above the dust storage section making sure to align the cabinet bolt holes
with the dust storage bolt holes.
6.
Lower t
he filte
r cabinet onto the dust storage section and align the bolt holes.
7.
Attach t
he fil
ter cabinet to the dust storage section using the supplied nuts,
washers and bolts. Tighten bolts for an adequate seal.
Figure 3
Support
plates
Support
legs
Cross braces
WARNING
Apply two strips of butyl adhesive on the dust storage section upper
outline. One strip should be applied inward of the bolt holes and one
strip outward of the bolt holes (Figure 4).
Figure 4
WARNING
The use of a spreader is recommended to avoid
d
amages to the filt
er cabinet.
Unside bag
removal
APPLY BUTYL
SUPPORT PLATES
SUPPORT LEGS
CROSS BRACES
