Horizontal downflow pleated cartridge dust collector
11
10.2 Electrical connection for DCT-1000 sequencer
The MAXIFLO dust collector is equipped with 115V solenoids which activate the cleaning valves.
These solenoids are grouped in a NEMA 4 ½ panel installed behind the cabinet, above the air tanks.
A differential control panel (DCP) may also be included on the electronic panel. Wiring for these
solenoids is factory assembled. The optional DCT-1000 activates the solenoids in sequence to
operate the cleaning valves. Drawing # 6 represents a typical connection with a starter to a DCT-
1000 sequencer card. The electronic panel is activated in simultaneously with the fan start-up. This
operation will regulates the pulses required as per the status of the filters.
Typical connection for DCT-500 series electronic board
Drawing # 5
Figure 5
TYPICAL CONNECTION FOR DCT-500
SERIES ELECTRONIC BOARD
