Applied Biosystems GeneAmp PCR System 9700, Руководство пользователя

Страница: 39 / 132

Instrument Setup 3-11
Defining the Idle
State Setpoint
Temperature
The Idle State Set Point temperature is the temperature at which the instrument will
remain when powered up, but idle.
IMPORTANT After a run is completed or terminated, there is approximately a 30 second delay
before the instrument attains the specified idle state temperature. This allows you to stop one
method and start another before the instrument temperature changes.
Defining the Baud
Rate for Your
Printer Port
The following section contains a table that lists serial board specifications and a
procedure that describes how to define the printer port value in the Baud Rate field.
Serial Board Specifications
You can connect the GeneAmp PCR System 9700 to any printer with a serial interface
board and the following specifications.
How to Set the Baud Rates
To define the Idle State Set Point temperature:
Step Action
1 Select the
Idle State Set Point
field.
2 Use the numeric keys and type in a temperature between 4.0° C and 99.9 °C.
Note The default is 25 °C.
3 Press
Enter
to accept your entry.
Baud Rate 9600
Parity NONE
Data Bits 8
Stop Bits 1
To set baud rates:
Step Action
1 Select the
Baud Rate
field.
2 You can take the following action:
Note Available baud rates are 19200, 9600, 4800, 1200, 600, and 300.
3 Press
Enter
to accept your entry.
If you want to... Then...
increase the baud rate Press Up.
decrease the baud rate Press Down.