Apollo RoadRunner MRH16, Руководство по эксплуатации

Страница: 50 / 69

Operating Manual
42
In active cameo mode, select the camera screen you want to display in the active cameo. After setting the camera number
to active cameo, the DVR moves the active cameo to the next cameo. When the camera number exists on the current
screen, the active cameo is changed with the existing camera number. When the camera number does not exist on the
current screen, the active cameo is replaced by the camera number. You can change the screen layout in this way.
Zoom Mode
You can enter the Zoom mode by selecting
Zoom
and choosing the camera number in the Live Monitoring menu
–
Camera Menu. For a few seconds after entering the Zoom mode, a rectangle displays on the screen. A rectangle shows
the area that will be enlarged. You can move the rectangle around by holding down the mouse button and dragging
the pointer. In the Zoom mode, click the right mouse button and select the enlargement ratio in the menu or scroll mouse
wheel and down enlarges the area in rectangle. Exit the Zoom mode by selecting
Zoom
again in the Camera Menu.
While in the Zoom mode, the icon displays if
Zoom
is selected in the Display setup screen (OSD tab).
PTZ Mode
If a user who has
PTZ Control
authority logs into the system, the user can control PTZ cameras. The DVR will control
cameras with Pan, Tilt and Zoom capabilities. Selecting
PTZ
and choosing the camera number in the Live Monitoring
menu
–
Camera Menu enters the PTZ mode, and selecting
PTZ
again in the Camera Menu exits the PTZ mode. When
in the PTZ mode, the icon
displays on the PTZ camera screen.
Position the mouse pointer at the bottom of the screen, and the following PTZ toolbar will display.
Clicking on the left side exits the toolbar. If you want to display the toolbar again, position
the mouse pointer at the bottom of the screen. Change the toolbar location by clicking the empty
space on the left side of the toolbar and drag it to where you want it located on the screen. Use
the arrow buttons on the toolbar to pan or tilt the camera in the direction you want. The other
controls on the toolbar perform as described below:
Zoom In / Out
Focus Near / Far
Iris Open / Close
Set / Load Preset
You can save camera position settings as “presets” so that you can go directly to desired views.
Once you have the camera at the desired settings, select on the tool bar, and
the
Set Preset
dialog box will appear. Select the number you want to assign
to the preset. Use the virtual keyboard to enter the preset name.
Select on the tool bar to load the PTZ preset and the
Move to Preset
dialog
box will appear. Select the desired preset to load the preset.
< Set Preset > < Move to Preset >
Figure 57 — PTZ Preset menu.