Anthos SMART TOUCH R7, Руководство по эксплуатации

Страница: 36 / 90

36 36 EN
R7
- OPERATING INSTRUCTION
5.2.3. "Power Pedal" foot control
Description of the parts .
1 Handle .
2 Foot control.
3 Dental chair movements.
4 Chip-air control or activation/deactivation of instrument spray function.
5 Water Clean System control or activation/deactivation of instrument spray
function.
6 Automatic dental chair return or programme "B” recall activation.
7 Patient rinse position or programme "A" recall activation.
8 Spray operation LED.
Foot control operation ( 2 ).
•
With instrument removed
- Pushing the pedal ( a ), the instrument is started.
The instrument's rpm (or power) can be adjusted by varying the pressure
exerted on the foot control.
NOTE
: the foot control adjusts the speed/power of the instrument
from the minimum to maximum value set from the instrument board.
- Release the foot control to stop instrument operation.
NOTE
: with the spray active, at the end of the operation a blast
of air is automatically activated to remove any residual drops of liquid
in the spray ducts.
• With instrument in place
When the foot control is pressed, all automatic dental chair movements
are automatically blocked.
Joystick for dental chair movement (3).
These buttons move the dental chair as follows:
Dental chair seat up.
Dental chair backrest up.
Dental chair seat down.
Dental chair backrest down.
To stop movement, release the button.
NOTE
: all dental chair movements are blocked when an instrument
is being used or the BIOSTER system is running.
NOTE : the joystick operating mode can be changed with the instru-
ment removed (see Paragraph 5.1.1.2.3.).
Left-hand button operation ( 4 ).
• Holding down the button for at least 2 seconds with instrument extracted:
Chip-air control: sends a jet of air to the turbine or the micromotor.
Air delivery is activated by pressing the button; the jet of air is interrupted
when the button is released.
• Briefly pressing the button with the instrument extracted:
Activation or deactivation of instrument spray.
WARNING!
A short acoustic signal warns of the switch.
When the LED ( 8 ) is on, it indicates operation with spray.
Right-hand button operation ( 5 ).
• Holding down the button for at least 2 seconds with instrument extracted:
Water Clean System control: sends a jet of running water to instruments
such as the turbine, the micromotor and the scaler for rinsing the spray
ducts. Water delivery is activated by pressing the button ( 5 ); when the
button is released, the jet of water is interrupted and a blast of air is au-
tomatically activated to remove any residual drops of liquid in the spray
ducts.
• Briefly pressing the button with the instrument extracted:
Activation or deactivation of instrument spray.
WARNING!
A short acoustic signal warns of the switch.
When the LEDs ( 8 ) are on, they indicate operation with spray.