CHAPTER 2 DECADE II DCC upgrade kit install guide, edition 5
35
Appendix A - Installation of 2
nd
internal cell cable
If the DECADE II has a s/n < 17100072 (upgrade kit p/n 171.0220) it is
necessary to install a second internal cell cable in the detector for sensor
board 2.
If your DECADE II has a s/n > 17100072 do not follow this procedure
and return to page 14 of the install guide.
To be able to install the internal cell cable for sensor board 2 it is necessary to
remove the top cover of the DECADE II. This is done in the following manner:
•
Back-side: Remove the two screws inside the housing of the
DECADE II using a Phillips screwdriver as depicted in figure 25.
•
Front-side: Remove the four screws in the oven compartment with a
Phillips screwdriver as depicted in figure 26 (see red arrows for
location).
•
The top cover can now be lifted (gently) of the DECADE II and
placed aside the detector as depicted in figure 27. Note: remove the
cover gently because the internal cell cable of sensor board 1 is fixed
at the bottom of the cover by means of a black cable clamp.
•
Release the cable clamp by opening the locking mechanism by
inserting a screwdriver as depicted in figure 28.
Содержание DECADE II
