Anritsu 37 C Series, Руководство по эксплуатации, Страница: 36 / 603

Step 3. Using a Phillips screwdriver, remove the two handles or four bumper
assemblies (and tilt bail, if installed) from the front of the unit, and
the four feet at the rear (Figure 2-1). Save the screws for later use.
NOTES
q The green-headed screws are metric threads and must be used
only in the appropriately tapped holes.
q The feet, handles, and bumpers are not reused in this applica-
tion.
Step 4. Remove the center screws from the rear of the left and right side cov-
ers.
Step 5. Remove the two side carrying handle screws (if so equipped) located
under the plastic handle ends.
Step 6. Remove the left and right side covers. These side covers are not reused
in this application.
Step 7. Install the two Rack Mount Handles using the green-headed screws
removed earlier.
Step 8. Secure the new left cover (2) from this retrofit kit to the left side chas-
sis of the instrument by installing the two center screws (6) to the top
and bottom and the previously removed center screw at the rear of the
left cover.
RACK MOUNT INSTALLATION
2-6 37XXXC OM
Table 2-1.
Removing Cover