andrews CWH 30/201, Руководство по эксплуатации

Страница: 22 / 48

End user 22 MAXXfl o EVO
Error
Code
Error Code Description Diag.
Code
Notes
317 Mains frequency outside per-
mitted range
Any Check electrical supply to appliance.
322 Water press 3 too high Any Water pressure inside the appliance is too high for safe opera-
tion. Operation will automatically resume once water pressure
is at or below maximum levels. Check that the appliance fl ow is
not restricted or blocked, or the water isolator valves are shut
off .
323 Water press 3 too low Any Water pressure inside appliance is too low for safe operation.
Operation will automatically resume once water pressure is at or
above 0.1 bar.
324 Input BX, same sensors Any BX sensor duplicated - check parameters
325 Input BX/extension module,
same sensors
Any BX extension module sensor duplicated - check parameters
327 Extension module, same
function
Any AGU2.5 extension module function duplicated - check param-
eter setup for the AGU2.5 extension module (“Confi guration”
menu)
335 Sensor input BX21 without
function
Any BX21 connected but not defi ned - defi ne parameters for this
sensor connected to the AGU2.5 extension module
336 Sensor input BX22 without
function
Any BX22 connected but not defi ned - defi ne parameters for this
sensor connected to the AGU2.5 extension module
353 Cascade fl ow sensor B10
missing
Any Check connections and confi guration of common fl ow tempera-
ture sensor (B10), which is located at the feed into the tank on
the front, left, mid section of the appliance
384 Extraneous light Any Ionisation current detected before ignition. Check ionisation
current (“Diagnostics producer” parameter 8329). If there is a
current present whilst the burner is in standby, turn of gas sup-
ply to check gas valve is closing completely. If current is still
present, remove ionisation probe and use a screwdriver to clear
the opening through the heat engine door before replacing the
probe.
385 Mains under voltage Any Mains voltage below 185v - check electrical supply to the appli-
ance.
386 Fan speed tolerance Any Fan outside allowed speed tolerance level. Check all wiring.
Check for possible air or fl ue restriction. Replace fan if all air-
ways are clear and wiring is good.
432 Function earth not connected Any No Ignition earth, X1 / X17 not connected or earth fault.
NA Operating mode button locked
- Cannot operate in DHW
mode (No fault displayed)
Any Remote system enable operating. Check to see if link wire is
still in place or controls wired to these terminals are closing this
circuit. When the appliance is operating via the volt free enable
signal, it is not possible to operate the appliance manually via
the GUI if the signal is not enabled (circuit closed).
2.10 ERROR CODES (CONTINUED)