Analog way ORCHESTRA ORC50, Руководство пользователя

Страница: 46 / 51

SOFT EDGE BLENDING
If you want to do a Soft Edge setup using only one unit, you
need to set the unit in “Embedded SEB” mode and connect the
Left projector to “Output 1” (Main) and the Right Projector to
“Output 2” (Preview).
In this “Embedded SEB” mode type of setup, your unit does
not have a Preview anymore, unless the unit is equipped with
an Optional Video Output Board. In this case, you can use the
Optional Video Outputs for your Preview purposes. (Adjust the
“Video Out” to the format of the monitor connected to it).
If you want to do a Soft Edge setup using multiple units, you
need to set all of the units in “Mixer” mode and connect the
projectors to the “Output 1” (Main) of each unit.
To do a proper and clean setup of your Soft Edge, follow the
following simple steps.
It is important to do the setup in the right order as follows:
1/ Switch ON your Unit(s).
2/ In the “Control” menu, do an “Erase Memories” (on all units).
3/ In the “Control” menu, do a “Default Values” (on all units).
4/ If you do a Softegde with only one unit, in the “Mode” menu
select the “Embedded SEB” mode.
If you do a Soft Edge with multiple units, in the “Mode” menu
select the “Mixer” mode.
5/ In the “Output” menu, set the “Output Format” at the same
resolution (native resolution) of the projectors that you use.
6/ Physically align the projectors so that their internal test
patterns are correctly displayed on the screen. To do a correct
projection, the projectors must be positioned at 90° with the
screen in the X and Y axes.
You can also use the “Grid” test pattern in the “Output” –
“Test Pattern” menu to help you properly align the projectors
together.
WARNING: Do not use the projectors’ Keystone function to
correct image parallelism problems. Using the Keystone will
make it impossible to use the Soft Edge Curves.
Soft Edge setup
SOFT EDGE BLENDING
44