Analog way ORCHESTRA ORC50, Руководство пользователя

Страница: 27 / 51

25
4/ In the Layout section, press the POS button, and with the
help of the joystick, move the rectangle on screen to the area
where your logo is. Resize the container to fit the logo if need
be, by pressing the Size button then adjusting with the joystick.
* NOTE * : to move the source, rather than the container
rectangle itself, press Source rather than Logo on the Position/
Size Adjust panel, and adjust size and position with the help of
the joystick as described in step 4.
5/ With the help of the corresponding knobs, slide values up or
down to set luma key parameters for your logo.
* NOTE * : as Frames do not handle keying, the Record Frames
tab does not give access to keying parameters.
6/ Once all your logo parameters are set, press Store . The
ORCHESTRA will display a progress status bar while the
device memorizes the logo.
7/ Press the OK button to return to the Screen Setup page.
* NOTE * : to record a logo in Soft Edge Blending Mode, you
need to press Source in the Position/Size Adjust panel, then
press Extended.
The Controls page allows users to select the Tally trigger on the
slave device. The Controls page also allows to reset a device
to its default values, or erase all image settings present on the
device.
To setup a tally signal with the ORCHESTRA :
1/ On the Screen Setup page of the ORCHESTRA , press
Controls.
2/ Press one of the four available Tally dropdown menu to
select the source you want to use as a trigger.
3/ Press the OK button to return to the Screen Setup page.
To erase all image settings on the slave device :
1/ In the Screen Setup page of the
ORCHESTRA
, press
Controls.
Controls Menu