115
USER MANUAL
A.b.g.
RC400T rear panel
Fig. 31 -
RC400T - rear panel
The rear panel is composed of:
- One power plug with a switch button
- One Ethernet plug for network connection
- One HDMI plug
- One USB plug
Note:
The HDMI plug will be fully functional in a future version.
A.c.
Getting started
A.c.a.
Start the RC400T
The RC400T controls LivePremier devices using standard Ethernet LAN networking.
1.
Connect the power supply cord on the rear panel.
2.
Connect the RC400T to the same network as the LivePremier unit.
3.
Turn the RC400T on (rear and front On/Off buttons).
A.c.b.
Turn the RC400T off
Press the On/Off button on the front panel and confirm to turn the RC400T off.
A.c.c.
Configure the RC400T network
1.
On the front panel, go to
Remote Device Network
>
Remote device LAN settings
.
2.
Select a device slot, set the IP address of the LivePremier unit and Apply (192.168.2.140 by default).
3.
If needed, repeat in the other device slots to add more connected units.
4.
If needed, go to
Console Network
, set the IP address of the RC400T and Apply (192.168.2.130 by
default).
The connection status is displayed on screen.
If the connection is not starting:
- Check that both IP addresses are on the same network and subnet.
- Check that no device has the same IP address (prevent IP conflicts).
- Check that all network configurations have been applied.
- Check that the LivePremier unit and RC400T have the latest firmware version installed.
- Check the network cables. If connecting the RC400T and the LivePremier unit directly, make sure to use an
Ethernet crossover cable. If a hub or switch is involved, use straight or crossed Ethernet cables.
Содержание AQL-C
Страница 121: ...www analogway com 121 USER MANUAL...
