Analog way AQL-C, Руководство пользователя

Страница: 113 / 121

www.analogway.com 113
USER MANUAL
APPENDICES
Appendix A. RC400T
The
RC400T
event controller has been designed to greatly increase the level of operational efficiency and to
give instant access to the crucial functionalities of the LivePremier image processor such as screens, layers,
sources and memories. The RC400T offers 56 user programmable buttons, a high-resolution T-bar and a
three-axis joystick for easy and fast programming (assign source in layers, load memories, etc.). The RC400T
can work with the Web RCS at the same time as both selections are synchronized.
Caution:
The fuse(s) present in the unit have not been designed to be replaceable. In case of problem, contact Analog
Way support.
Fig. 30 - RC400T
A.a. Installation
The RC400T has been designed to be used directly on a table. It is equipped with a wrist rest and four anti-
slip rubber feet. The wrist rest can be removed for a recessed installation of the RC400T.
Recessed installation - Remove the wrist rest
1. Turn the rear panel power switch off and disconnect the power supply.
2. Remove the screws of the wrist rest on both sides of the RC400T using a T10 Torx screwdriver.
3. Safely remove the wrist rest.
The RC400T is ready for recessed installation. Before embedding the RC400T, connect all cables and turn the
rear panel power switch on or make sure they can be accessed.
RC400T dimensions: L 570 mm x H 122.5 mm x P 382 mm (W 22.44’’ x H 4.82’’ x D 15.04’’)